1. ovládání teploty
Barrel temperature: Reasonably set the temperature of each section of the barrel. The temperature of the feeding section should not be too high, and it can even be cooled appropriately to prevent the material from bridging or melting prematurely near the feeding port. The temperature of the compression section and the homogenization section can be set higher, but avoid excessive temperature causing material degradation or burning. In Obecně, teplota barelu by neměla být vyšší než 190 stupňů .
Teplota hlavy a plísní: Teplota hlavy a formy má důležitý vliv na vytlačování na vytlačování . Teplota hlavy a plísní by měla být přesně kontrolována podle specifického materiálu a požadavků na produkt, aby se zabránilo spalování materiálu v důsledku nadměrné teploty .
2. Optimalizace rychlosti šroubu
Reasonably control the screw speed: Too high a screw speed will produce a large shear force, causing heat-sensitive materials to degrade or burn. At the same time, too low a screw speed will cause the material to stay in the barrel for too long, which may also have an adverse effect on the material. Therefore, it is necessary to select a suitable screw speed according to the nature of the material and the extrusion process requirements to ensure uniform plasticization and smooth Přeprava materiálu .
3. ovládání doby pobytu materiálu
Optimize extrusion speed: Increasing the extrusion speed can reduce the residence time of the material in the barrel and reduce the risk of burning. However, the increase in extrusion speed needs to be carried out under the premise of ensuring that the material is fully plasticized and mixed, otherwise it may affect the product quality. The extrusion speed can be increased by optimizing the screw structure, improving the heating and cooling efficiency, and other Opatření .
4. Optimalizace systému chlazení
Posílit schopnost řízení chlazení a teploty: Při vyšších rychlostech vytlačování je třeba posílit schopnost kontroly chlazení a teploty extrudéru, aby se zajistilo tvarování a chlazení produktu . Systém chlazení by měl zajistit, aby byl materiál extrudovaný z matrice vychlazen
5. předběžné ošetření materiálu
Zajistěte kvalitu materiálu: Před vytlačováním předem ošetřujte materiál, jako je sušení a screening, aby se odstranilo nečistoty a vlhkost v materiálu, aby se zabránilo nečistotům způsobit místní přehřátí a pálení během procesu vytlačování .
Vyvarujte se používání spálených materiálů: Pokud byl materiál spálen, mělo by se mu zabránit tomu, aby byl znovu použit ve výrobě . pro mírně spálené materiály, mohou být přidány do jiných materiálů v malých množstvích po řádném ošetření (jako je přidání změkvačů a plastikórů) .
6. Údržba a kontrola zařízení
Pravidelná kontrola vybavení: Pravidelně kontrolujte vytápěcí systém extrudéru, chladicí systém, šroub a další klíčové komponenty, aby se zajistilo jejich normální provoz . Vyčistit nashromážděné materiály v hlaveň a včas zabránit, aby se nahromaděné materiály po dlouhou dobu vytápěly {.} .}}.}.}}
Senzory kalibrace teplotních senzorů: Pravidelně kalibrujte teplotní senzory a kontrolní systémy, aby byla zajištěna přesnost měření a kontroly teploty .





